Kia Cee'd: Panoramaroof / Roll Blind Repair procedures

Replacement
[Removal]
1.
Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly")
2.
Open the movable glass fully.
3.
Loosen the roll blind lower bracket (A) mounting screws.
  
Do not damage the screws.

4.
Remove the roll blind (A) by pulling it at a right angle.
  
When you removing it, be care of that an edge (B) is dashed against the frame of vehicle because the roll blind tension loosen.

[Installation]
1.
Installation is the roll blind (A).
  
When you install it, be care of that an edge (B) is dashed against the frame of vehicle because the roll blind tension loosen.

2.
Install the screws to the roll blind lower bracket (A).
  
Do not damage the screws.

3.
Install the roof trim.
Panoramaroof Deflector Repair procedures
Replacement 1. Open the movable glass fully. 2. Loosen the panoramaroof deflector side's mounting screw (A). ...

Panoramaroof Assembly Components and components location
Component Location   1. Panoramaroof assembly ...

Other information:

Kia Cee'd JD Service Manual: Trailing Arm Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 1 ...

Kia Cee'd JD Service Manual: PTC Heater (Gasoline Engine) Description and operation
Descriptionddd The PTC (Positive Temperature Coefficient) heater is installed at the exit or the backside of the heater core. The PTC heater is an electric heater using a PTC element as an auxiliary heating device that supplements deficiency of interior heat source in high ...

© 2017-2024 www.kceed.com