Inspection |
1. |
After disconnecting the vapor hose from the PCV valve, remove the PCV
valve.
|
2. |
Reconnect the PCV valve to the vapor hose.
|
3. |
Run the engine at idle, then put a finger over the open end of the PCV
valve and make sure that intake manifold vacuum can be felt.
|
4. |
If the vacuum is not felt inspect PCV operation, if operating correctly
clean or replace the vapor hose.
|
Kia Cee'd JD Service Manual: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the BCM unit (A) after loosening nuts.
...
Kia Cee'd JD Service Manual: ABS Control Module Repair procedures
Removal [LHD]
1.
Turn the ignition switch OFF.
2.
Pull up the lock of the HECU connector (A), and then disconnect the
connector.
3.
Remove the brake fluid from the master cylinder reservoir wi ...