Kia Cee'd: Engine Mechanical System / Repair procedures
Compession Pressure Inspection |
If the there is lack of power, excessive oil consumption or poor fuel
economy, measure the compression pressure.
|
1. |
Make sure the oil in the crankcase is of the correct viscosity and at
the correct level and that the battery is correctly charged. Operate
the vehicle until the engine is at normal operating temperature. Turn
the ignition switch to the OFF position.
|
2. |
Remove the engine cover.
|
3. |
Disconnect the injector extension connector (A) and the ignition coil
connectors (B).

|
4. |
Remove the ignition coils (A).

|
5. |
Remove the spark plugs.
Using a 16mm plug wrench, remove the 4 spark plugs.
|
6. |
Check the cylinder compression pressure.
(1) |
Insert a compression gauge into the spark plug hole.

|
(2) |
Set the throttle plate in the wide-open position.
|
(3) |
While cranking the engine, measure the compression pressure.
Always use a fully charged battery to obtain engine
speed of 250rpm or more.
|
|
(4) |
Repeat step 1) through 3) for each cylinder.
This measurement must be done in as short time as possible.
|
Compression pressure
Standard : 1225.83kPa (12.5kg/cm², 177.79psi) (200~250
rpm)
Minimum : 1078.73kPa (11.0kg/cm², 156.46psi)
Difference between each cylinder :
98kPa (1.0kg/cm², 14psi) or less
|
|
(5) |
If the cylinder compression in one or more cylinders is low,
pour a small amount of engine oil into the cylinder through
the spark plug hole and repeat step 1) through 3) for cylinders
with low compression.
•
|
If adding oil helps the compression, it is likely that
the piston rings and/or cylinder bore are worn or damaged.
|
•
|
If pressure stays low, a valve may be sticking or seating
is improper, or there may be leakage past the gasket.
|
|
|
7. |
Install the spark plugs.
Tightening torque :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
|
|
8. |
Install the ignition coil.
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
9. |
Connect the injector extension connector and the ignition coil connectors.
|
10. |
Install the engine cover.
|
Specifications
Description
Specifications
Limit
General
Type
In-line, DOHC
...
Troubleshooting
Symptom
Suspect area
Remedy
Engine misfire with abnormal internal lower engine noises.
Loose or ...
Other information:
Kia Cee'd JD Owners Manual: Map lamp
■ Type A
■ Type B
Press the lens (1) to turn the map lamp
on or off
/OFF (2) : The lamps are
off even
if a door is opened.
/DOOR (3) :
- The map lamp comes on when a door
is opened. If you close the door, the
lamps go out after approximately 30
seconds.
- The ma ...
Kia Cee'd JD Service Manual: Transmitter Specifications
Specification
Item
Description
Power source
3V
Operating temperature
-20°C ~ +60°C (-4°F ~ +140°F)
RF frequency
433.92MHz
Battery
...