Kia Cee'd: Blind Spot Detection system / Repair procedures
| Diagnosis With GDS |
| 1. |
BSD system defects can be quickly diagnosed with the GDS. GDS operates
actuator quickly to monitor, input/output value and self diagnosis.
|
| 2. |
Connect the cable of GDS to the data link connector in driver side crash
pad lower panel, turn the power on GDS.
|
| 3. |
Select the vehicle model and then BSD system.
|
| 4. |
Select "Input/output monitoring", if you want to check current data
of BSD system.
|
| 5. |
If you want to check each module operation forcefully, select "Actuation
test".
|
| 6. |
Ignition "OFF", connect GDS.
|
| 7. |
Ignition "ON” & Engine "OFF", select BSD system and "BSD Radar Calibration"
mode.
|
| 8. |
The GDS will show the BSD Reset function steps.
|
| 9. |
The BSD initialization procedure will be performed.
|
Description and operation
Description
BSD is a system that uses two magnetic wave radar sensors attached on the rear
panel to measure the distance from the following vehicles and provides the sensing
...
Blind Spot Detection Unit" Schematic diagrams
Circuit Diagram
...
Other information:
Ford Escape 2020-2022 Owners Manual: Connected Vehicle Data
The modem has a SIM. The
modem was enabled when your
vehicle was built and periodically
sends messages to stay connected to the
cell phone network, receive automatic
software updates and send vehicle-related
information to us, for example diagnostic
information. These messages could
include ...
Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform
[NON-ISG]
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position
Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing
by using these signals.
Generally CkPS signal is used to dete ...