Kia Cee'd: Body Control Module (BCM) / Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Body Control Module (BCM) / Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the BCM unit (A) after loosening nuts.

Installation
1.
Install the BCM unit.
2.
Install the crash pad lower panel.
3.
Connect the negative (-) battery terminal.
BCM Diagnosis With GDS

1.
The body control module can diagnose by using the GDS more quickly.
The BCM communicates with the GDS and then reads the input/output value and drives the actuator.
2.
To diagnose the BCM function, select the menu of model and body control module.
3.
Select "Input/output monitoring", if you will check current data of body network system. It provides input/output status of each module.
–
BCM service data, CLU service data, SJB service data
4.
If you will check each module data operation forcefully, select "Actuation test".

5.
If you want to change user option, select “user option”.

Description and operation
Description CAN Communication Netrwork Function   Function Description Front Washer & Wiper – ...

IMS (Integrated Memory)
...

Other information:

Kia Cee'd JD Service Manual: Power Window Switch Schematic diagrams
Circuit Diagram Driver Power Window Switch Passenger & Rear Power Window Switch ...

Kia Cee'd JD Owners Manual: Condition of ISG system operation
The ISG system will operate under the following condition: - The driver’s seat belt is fastened. - The driver’s door and engine hood are closed. - The brake vaccum pressure is adequate. - The battery is sufficiently charged. - The outside temperature is between -2°C to 35°C (28.4°F ...

© 2017-2026 www.kceed.com