Kia Cee'd: Keyless Entry and Burglar Alarm / Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Keyless Entry and Burglar Alarm / Repair procedures

Inspection

Front Door Lock Module Inspection

1.	Remove the front door trim. (Refer to Body - "Front Door Trim")

2.	Remove the front door module. (Refer to Body - "Front Door Module")

3.	Disconnect the connector from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily. [Central Lock] [Dead Lock]

5.	Check for continuity between the terminals in each switch position according to the table. [Central Lock]

Rear Door Lock Module Inspection

1.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

2.	Remove the rear door module. (Refer to Body - "Rear Door Module")

3.	Disconnect the connector from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily. [Central Lock] [Dead Lock]

5.	Check for continuity between the terminals in each switch position according to the table. [Central / Dead Lock]

Tailgate Release Module Inspection

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Disconnect the connector from the actuator.

3.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Open Switch Inspection

1.	Remove the tailgate open switch bracket (A) after loosening screws.

2.	Remove the switch and disconnect the connector from the switch.

3.	Check for continuity between the terminals in each switch position according to the table.

Door Switch Inspection

Remove the door switch and check for continuity between the terminals.

Hood Switch Inspection

1.	Disconnect the connector from the hood switch (A).

2.	Check for continuity between the terminals and ground according to the table.

Burglar Horn Inspection

1.	Remove the burglar horn (A) after removing 1 bolt and disconnect the connector from the burglar horn.

2.	Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.

3.	The burglar horn should make a sound. If the burglar horn fails to make a sound replace it.

Description and operation

Description Burglar Alarm State [B/A State] B/A State Description DISARM 1) In "DISARM ...

Transmitter Specifications

Specification Item Description Power source 3V Operating temperature -20°C ~ +60°C (-4°F ~ ...

Other information:

Kia Cee'd JD Owners Manual: With the door handle
Driver’s door and front passanger’s door (if equipped) If the inner door handle is pulled when the door is locked, the door will unlock and open. Rear door (if equipped) If the inner door handle is pulled once when the door is locked, the door will unlock. If the inner door handl ...

Kia Cee'd JD Owners Manual: Non-operational conditions of parking assist system
Parking assist system may not operate normally when: 1. Moisture is frozen to the sensor. (It will operate normally when moisture melts.) 2. Sensor is covered with foreign matter, such as snow or water, or the sensor cover is blocked. (It will operate normally when the material is remo ...