Kia Cee'd: Restraint / Repair procedures

Kia Cee'd JD Service Manual / Restraint / Repair procedures

Component Replacement After Deployment

Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.

When the front airbag(s) deployed after a collision, replace the following items.

–

SRSCM

–	Deployed airbag(s)

–	Seat belt pretensioner(s)

–	Front impact sensors

–	SRS wiring harnesses

–	Inspect the clock spring for heat damage. If any damage found, replace the clock spring.

When the side/curtain airbag(s) deployed after a collision, replace the following items.

–

SRSCM

–	Deployed airbag(s)

–	Side impact sensor(s) for the deployed side(s)

–	SRS wiring harnesses

After the vehicle is completely repaired, confirm the SRS airbag system is OK.

–	Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.

Description and operation

Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the wa ...

Components and components location

Components [LHD] 1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring 4. Seat Belt Pretensioner (BPT) 5. Side Impact Sensor (SIS) 6. Side A ...

Other information:

Kia Cee'd JD Owners Manual: Driver's Attention
The driver must be cautious in the below situations for the system may not assist the driver and may not work properly. Do not stick or attach anything to the windshield in front of the camera as this may reduce effectiveness or cause one more of the systems dependent on the ca ...

Kia Cee'd JD Service Manual: Front Seat Shield Inner Cover Components and components location
Component Location 1. Front seat shield inner cover ...