Kia Cee'd: Steering wheel / Repair procedures

Replacement
1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels can face straight ahead.
3.
Remove the airbag module.
4.
Disconnect the connector & lock nut (A) and then remove the steering wheel (B) by using special service tools (09561-11001).
Tightening torque :
39.2 ~ 44.1 N.m(4.0 ~ 4.5 kgf.m, 28.9 ~ 32.5 lb-ft)

  
Do not hammer on the steering wheel to remove it; it may damage the steering column.
5.
Installation is the reverse of the removal.
Disaseembly
1.
Loosen the screw (A-3ea) and then remove the lower cover (B) from the steering wheel body.
Tightening torque :
7.8 ~ 11.8 N.m(0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

2.
Remove the garnish (A).

3.
Remove the wiring (A).

4.
Loosen the screw (A-6ea) and then remote control switch assembly (B) from the garnish.
Tightening torque :
7.8 ~ 11.8 N.m(0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.
Installation is the reverse of the removal.
Components and components location
Component   1. Airbag module 2. Remote control assembly 3. Garnish 4. Steering wheel 5. Wiring 6. Lower cover ...

Heated Steering wheel Description and operation
Description "The heated steering wheel features an internal heating element that maintains the steering wheel temperature to a consistent level during cold seasons. A heater ...

Other information:

Kia Cee'd JD Service Manual: Variable Intake Solenoid (VIS) Valve Description and operation
Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or closes this valve according to engine condition (Refer to below table). ...

Ford Escape 2020-2022 Owners Manual: Mobile App Voice Commands (If Equipped)
The following voice commands are always available: There are also voice commands that you can use when app(s) are connected to SYNC 3: ...

© 2017-2022 www.kceed.com