Kia Cee'd: Clutch Switch / Repair procedures

Inspection
Signal Circuit Inspection
1.
Check clutch switch pull-up voltage
(1)
IG KEY "OFF", ENGINE "OFF".
(2)
Disconnect clutch switch connector.
(3)
IG KEY "ON".
(4)
Measure the voltage between signal terminal of clutch switch harness connector and chassis ground.
Specification : 11.5V ~ 13.0V
2.
Check open in clutch switch signal circuit
(1)
IG KEY "OFF", ENGINE "OFF".
(2)
Disconnect clutch switch connector and ECM connector.
(3)
Check continuity between signal terminal of clutch switch harness connector and ECM harness connector.
Specification : Continuity ( below 1.0Ω )
Ground Circuit inspection
1.
IG KEY "OFF", ENGINE "OFF".
2.
Disconnect clutch switch connector.
3.
Check continuity between clutch switch connector terminal 1 and chassis ground.
Specification : Continuity ( below 1.0Ω )
Component Inspection
1.
Remove the clutch switch.
2.
Push the clutch switch in the direction of the arrow to make sure that continuity is cut off.

  
 
Condition
Clutch Pedal pressed
Clutch Pedal Released
Switch Operation
ON (below 1.0Ω )
OFF ( Infinite Ω )

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect clutch switch connector (A).

3.
Remove the clutch switch (B) by loosening a nut (A).

Installation
1.
Install in the reverse order of removal.
2.
Adjust the clutch switch.
(1)
Adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.
Standard gap range:
0.5 ~ 1.0 mm (0.0197 ~ 0.0394 in.)
(2)
Tighten the nut (B) with the specified torque.
Tightening torque:
7.8 ~ 9.8 N (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Specifications
Specifications   Item Specifications Working voltage  DC 12V  Operating force 14.7 ± ...

Ignition Lock Switch
...

Other information:

Kia Cee'd JD Service Manual: Dual Clutch Transmission(DCT) Repair procedures
Removal 1. Remove the engine cover. (Refer to Engine Mechanical System - "Engine cover") 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air cleaner") ...

Kia Cee'd JD Service Manual: Manual Transaxle Repair procedures
Removal 1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") ...

© 2017-2022 www.kceed.com