Kia Cee'd: Parking brake - Hand type / Releasing the parking brake

To release the parking brake, first apply the foot brake and pull up the parking brake lever slightly. Secondly press the release button (1) and lower the parking brake lever (2) while pressing the button.

WARNING

Check the brake warning light by turning the ignition switch ON (do not start the engine). This light will illuminate when the parking brake is applied with the ignition switch in the START or ON position.

Before driving, be sure the parking brake is fully released and the brake warning light is off.

If the brake warning light remains on after the parking brake is released while the engine is running, there may be a malfunction in the brake system. Immediate attention is necessary.

If at all possible, cease driving the vehicle immediately. If that is not possible, use extreme caution while operating the vehicle and only continue to drive the vehicle until you can reach a safe location or repair shop.

Applying the parking brake
To engage the parking brake, first apply the foot brake and then without pressing the release button in, pull the parking brake lever up as far as possible. In addition it is recommended tha ...

Electric parking brake (EPB)
...

Other information:

Kia Cee'd JD Service Manual: Front Pillar Trim Repair procedures
Replacement    • Put on gloves to protect your hands.    • Use ...

Kia Cee'd JD Service Manual: Front Seat Belt Buckle Components and components location
Component Location   1. Front seat belt buckle ...

© 2017-2025 www.kceed.com