Kia Cee'd: Troubleshooting / Refrigerant line Repair procedures

Replacement
1.
Discharge refrigerant from refrigeration system.
2.
Replace faulty tube or hose.
  
Cap the open fittings immediately to keep moisture or dirt out of the system.
3.
Tighten joint of bolt or nut to specified torque.
  
Connections should not be torque tighter than the specified torque.
4.
Evacuate air in the refrigeration system and charge system with refrigerant.
Specified amount : 500 ± 25 g (17.6 ± 0.88 oz.)
5.
Inspect for leakage of refrigerant.
Using a gas leak detector, check for leakage of refrigerant.
6.
Inspect A/C operation.
Compressor Oil Repair procedures
Oil Specification 1. The R-134a or R-1234yf system requires synthetic compressor oil (PAG) whereas the R-12 system requires mineral compressor oil. The two oils ...

Compressor Description and operation
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pr ...

Other information:

: Programming the Garage Door Opener to Your Gate Opener Motor
Gate Operator / Canadian Programming Canadian radio-frequency laws require transmitter signals to “time-out” (or quit) after several seconds of transmission – which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate ...

Kia Cee'd JD Owners Manual: Inside light (5 Door and Wagon)
1. Turn off the engine. 2. Open the tailgate. 3. Remove the service cover using a flatblade screwdriver. 4. Loosen the retaining nuts. 5. Disconnect the power connector. 6. Remove the rear combination light assembly from the body of the vehicle. Tail light or tail and stop light (Bul ...

© 2017-2026 www.kceed.com