Inspection |
1. |
Remove the 4P connector from the rear wiper motor.
|
2. |
Connect battery positive (+) and negative (-) cables to terminals 3
and 4 respectively.
|
3. |
Check that the motor operates normally. Replace the motor if it operates
abnormally.
|
1. |
Operate the motor at low speed using the stalk control.
|
2. |
Stop the motor operation anywhere except at the off position by disconnecting
terminal 3.
|
3. |
Connect terminals 2 and 3.
|
4. |
Connect the positive (+) lead from the battery to terminal 1 and the
negative (-) lead to terminal 4.
|
5. |
Check that the motor stops running at the off position.
|
Removal |
1. |
Detach the rear wiper cap (A).
|
2. |
Remove the rear wiper arm & blade (A) after removing rear wiper nut
(B).
|
3. |
Open the tailgate then remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
4. |
Disconnect the rear wiper motor connector (B) then remove the rear wiper
motor (A) after loosening bolts (3EA).
|
Installation |
1. |
Install the rear wiper motor assembly and the grommet.
|
2. |
Install the tailgate trim.
|
3. |
Set the rear wiper blade and to the lowest defogger heat line and tailgate
glass.
|
4. |
Install the rear wiper cap and rear wiper nut.
|
Kia Cee'd JD Owners Manual: If you do decide to pull a trailer
Here are some important points if you decide to pull a trailer:
Consider using a sway control.You can ask a hitch dealer about sway
control.
Do not do any towing with your car during its first 2,000 km (1,200
miles) in order to allow the engine to properly break in. Failure
to heed th ...
Kia Cee'd JD Owners Manual: Instant fuel economy (L/100 km or MPG)
This mode calculates the instant fuel consumption
during the last few seconds.
✽ NOTICE
If the vehicle is not on level ground or
the battery power has been interrupted,
the “Distance to empty” function
may not operate correctly.
The trip computer may not register
additi ...