| Inspection |
| 1. |
With the washer motor connected to the reservoir tank, fill the reservoir
tank with water.
|
| 2. |
Connect positive (+) battery cables to terminal 1 and negative (-) battery
cables to terminal 2 respectively.
|
| 3. |
Check that the motor operates normally and the washer motor runs and
water sprays from the front nozzles.
|
| 4. |
If they are abnormal, replace the washer motor.
[Front & Rear washer]
|
Rear Washer Switch Repair proceduresKia Cee'd JD Service Manual: Rear Oil Seal Repair procedures
Removal
1.
Remove the transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
2.
MT : Remove the flywheel.
(Refet to Cylinder Block - "FlyWheel")
3.
...
Kia Cee'd JD Service Manual: Knock Sensor (KS) Description and operation
Description
Knocking is a phenomenon characterized by undesirable vibration and noise and
can cause engine damage. Knock Sensor (KS) is installed on the cylinder block
and senses engine knocking.
When knocking occurs, the vibration from the cylinder block is applied as pre ...