Replacement |
1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the rear wheel and tire (A) from rear hub.
|
3. |
Loosen the bolt & nut and then remove the rear upper arm (A) from the
rear axle.
|
4. |
Loosen the bolt & nut and then remove the rear upper arm (A) from the
sub frame.
|
5. |
Install in the reverse order of removal.
|
6. |
Check the wheel alignment.
|
Inspection |
1. |
Check the bushing for wear and deterioration.
|
2. |
Check the rear lower arm for deformation.
|
3. |
Check the coil spring and spring pad for deterioration and deformation.
|
4. |
Check for all bolts and nut.
|
Kia Cee'd JD Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within ...
Kia Cee'd JD Service Manual: Dynamic Damper Components and components location
Components
1. BJ
assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic
damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ
boot
10. Spider assembly
11. Retainer ring
12. TJ housing
...