Kia Cee'd: Rear Suspension System / Rear Stabilizer Bar Repair procedures

Kia Cee'd JD Service Manual / Suspension System / Rear Suspension System / Rear Stabilizer Bar Repair procedures

Replacement

1.	Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.

Remove the rear wheel and tire (A) from rear hub.

Tightening torque:

88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

•	Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

Loosen the nut and then remove the rear stabilizer link (A) from the rear lower arm & stabilizer bar.

Tightening torque:

98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

Loosen the mounting bolt and then remove the stabilizer bar (A) from the sub frame.

Tightening torque:

44.1 ~ 53.9N.m(4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)

5.	Install in the reverse order of removal.

Inspection

1.	Check the rear stabilizer bar for deformation.

2.	Check the rear stabilizer link ball joint for damage.

Rear Lower Arm Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wh ...

Rear Assist Arm Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wh ...

Other information:

Kia Cee'd JD Service Manual: Drive Belt Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Loosen the alternator tension adjusting bolt (A) to loosen tension. 3. Remove the drive belt (A). Inspection ...

Kia Cee'd JD Service Manual: Intake Manifold Repair procedures
Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal. 3. Remove the air cleaner assembly. (Refer to Intake And Exhaust System-"Air Cleaner") ...