Kia Cee'd: Body Side Molding / Rear Spoiler Repair procedures
| • |
When prying with a flat-tip screwdriver, wrap it with protective
tape, and apply protective tape around the related parts, to
prevent damage.
|
| • |
Put on gloves to protect your hands.
|
|
| • |
Take care not to scratch the body surface.
|
|
| 1. |
Remove the tail gate upper trim.
(Refer to Tail Gate - "Tail Gate Trim")
|
| 2. |
Disconnect the high mounted stop lamp connector (A) and washer nozzle
(B).
|
| 3. |
Loosen the rear spoiler mounting nuts.
|
Tightening torque :
5.9 ~ 6.4 N.m (0.6 ~ 0.65 kgf.m, 4.3 ~ 4.7 lb-ft)
|
|
| 4. |
Remove the rear spoiler (A).
|
| 5. |
Install in the reverse order of removal.
| •
|
Make sure the connector is connected properly.
|
| •
|
Replace any damaged clips.
|
|
|
Replacement
[General Type]
•
When prying with a flat-tip screwdriver, wrap it wit ...
Replacement
•
When prying with a flat-tip screwdriver, wrap it with protective
...
Other information:
Kia Cee'd JD Service Manual: Description and operation
Cruise Control
The cruise control system is engaged by the cruise "ON/OFF" main switch located
on right of steering wheel column. The system has the capability to cruise,
coast, accelerate and resume speed.
It also has a safety interrupt, engaged upon depressing ...
: Wipers
Wiper Precautions
Do not operate the wipers on a dry
windshield. This could scratch the glass or
damage the wiper blades. Use the
windshield washers before wiping a dry
windshield.
Fully defrost the windshield before you
switch the windshield wipers on.
Switch the windshield wipers off before
...
Roof Garnish Repair procedures
Front Wheel Guard Repair procedures