Kia Cee'd: Rear Suspension System / Rear Shock Absorber Repair procedures

Kia Cee'd JD Service Manual / Suspension System / Rear Suspension System / Rear Shock Absorber Repair procedures

Replacement

1.	Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.

Remove the rear wheel and tire (A) from rear hub.

Tightening torque:

88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

•	Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

Loosen the bolt & nut and then disconnect the shock absorber (A) from the rear axle.

Tightening torque:

137.3 ~ 156.9N.m(14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)

Loosen the mounting bolts and then remove the shock absorber (A).

Tightening torque:

49.0 ~ 63.7N.m (5.0 ~ 6.5kgf.m, 36.2 ~ 47.0lb-ft)

Install in the reverse order of removal.

Don't reuse rear shock absorber upper self-locking nut.

Inspection

1.	Check the rubber parts for wear and deterioration.

2.	Compress and extend the piston rod (A) and check that there is no abnormal resistance or unusual sound during operation.

Disposal

1.	Fully extend the piston rod.

Drill a hole on the (A) section to remove gas from the cylinder.

•	The gas coming out is harmless but be careful of chips that may tly when driling.

Rear Shock Absorber Components and components location

Components 1. Rear insulator cover 2. Locking nut 3. Plpe 4. Rear bracket assembly 5. Bumper rubber 6. Protector 7. Rear shock absorber as ...

Rear Upper Arm Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wh ...

Other information:

Kia Cee'd JD Owners Manual: Parking brake - hand type
Checking the parking brake Check the stroke of the parking brake by counting the number of “clicks’’ heard while fully applying it from the released position. Also, the parking brake alone should securely hold the vehicle on a fairly steep grade. If the stroke is more or less th ...

Kia Cee'd JD Service Manual: Accelerator Pedal Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation bolt (B) and nut ...