Kia Cee'd: Rear Seat Belt / Rear Seat Belt Buckle Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Buckle Repair procedures

Replacement

1.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Disconnect the rear seat belt buckle connector (B).

Loosen the mounting bolt, and then remove the rear seat belt buckle (A).

[LH]

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

[RH]

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

Install in the reverse order of removal.

•	Replace any damaged clips.

•	Make sure the connector is plugged in properly.

Rear Seat Belt Buckle Components and components location

Component Location 1. Rear seat belt buckle [LH] 2. Rear seat belt buckle [RH] ...

Body Electrical System

...

Other information:

Kia Cee'd JD Service Manual: Description and operation
Description Clutch switch is connected to clutch pedal and transmits clutch operating state to ECM. When clutch pedal is depressed during driving, engine load changes from loaded to none loaded condition. However, ECM regards vehicle to be loaded becuase VSS signal is s ...

Kia Cee'd JD Owners Manual: Driver’s Attention
The driver must be cautious in the below situations, because the system may not detect other vehicles or objects in certain circumstances. The vehicle drives on a curved road or through a tollgate. The vehicle is turning left or right at a crossroad. The sensor is polluted with r ...