Kia Cee'd: Rear Parking Assist System / Rear Parking Assist System Switch Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Rear Parking Assist System / Rear Parking Assist System Switch Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the console upper tray complete. (Refer to Body - "Floor Console Assembly")

3.	Disconnect the connector (A).

4.	Loosen screws after connecting the connector. Remove the parking assist system switch (A).

Installation

1.	Install the parking assist system switch and the console upper tray complete.

2.	Connect the negative (-) battery terminal.

Parking Assist Sensor Repair procedures

Removal [Rear Bumper] 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - &q ...

Button Engine Start System

...

Other information:

: Drive Modes
Deep Snow/Sand (If Equipped) Use this mode to aid you in getting your vehicle unstuck from deep snow or sand. Note: The intent of your all-wheel drive vehicle is not for off-road use. The all-wheel drive feature allows for driving on relatively level surfaces, obstruction free and similar to ...

Kia Cee'd JD Service Manual: Rain Sensor Repair procedures
Inspection Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor input signal. 2. If the wiper switc ...