Kia Cee'd: Cylinder Block / Rear Oil Seal Repair procedures

Kia Cee'd JD Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Repair procedures

Removal
1.
Remove the transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
2.
MT : Remove the flywheel.
(Refet to Cylinder Block - "FlyWheel")
3.
AT : Remove the drive plate.
(Refet to Cylinder Block - "Drive Plate")
4.
Remove the rear oil seal(A).

Installation
1.
Install the rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using the SST(09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

2.
MT : Install the flywheel.
(Refet to Cylinder Block - "FlyWheel")
3.
AT : Install the drive plate.
(Refet to Cylinder Block - "Drive Plate")
4.
Install the transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
Rear Oil Seal Components and components location
Components   1. Rear oil seal ...

Cylinder Block Components and components location
Components   1.  Cylinder block 2.  Ladder frame 3.  Crank shaft 4.  Crank shaft upper bearing 5.  Crank shaft lower bearin ...

Other information:

Kia Cee'd JD Service Manual: Components and components location
Components Location   1. Rear shock absorber 2. Rear trailing arm 3. Rear upper arm 4. Rear stabilizer bar 5. Rear lower arm 6. Rear assist arm ...

Kia Cee'd JD Service Manual: Components and components location
Component   1. Concentric slave cylinder assembly 2. Manual transaxle ...

© 2017-2026 www.kceed.com