| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the lighting switch of the multifunction switch.
(Refer to Multifunction Switch)
|
| 3. |
With the front fog lamp switch, make sure that continuity exists between
the terminals below.
If continuity is not as specified, replace the multi-function switch.
Fog Lamp
|
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
|
| 3. |
Disconnect the rear bumper main connector (A).
|
| 4. |
Disconnect the rear fog lamp connector (A) and ultrasonic sensor connector
(B).
Separate the wiring harness fixed clip (A) from the rear fog lamp assembly.
|
| 5. |
Remove the bulb (A) after turning it counterclockwise.
|
| 6. |
Remove the rear fog lamp assembly (A) after loosening the mounting screws.
|
| Installation |
| 1. |
Install the rear fog assembly and connect the connector.
|
| 2. |
Install the rear bumper cover.
|
Front Fog Lamps Repair procedures
High Mounted stop lamp Repair proceduresKia Cee'd JD Service Manual: Relay Box (Passenger Compartment) Repair procedures
Fuse Inspection
1.
Be sure there is no play in the fuse holders, and that the fuses are
held securely.
2.
Be sure the fuse capacities for each circuit correct.
3.
Check whether or not the fuse is brok ...
Kia Cee'd JD Owners Manual: Disarmed stage
The system will be disarmed when:
Transmitter
- The door unlock button is pressed.
- The engine is started.
- The ignition switch is in the “ON” position
for 30 seconds or more.
Smart key
- The door unlock button is pressed.
- The button of the front outside door is
pressed while carr ...