Kia Cee'd: Rear Door / Rear Door Trim Repair procedures

Replacement
  
Put on gloves to protect your hands.
  
Be careful not to scratch the door trim and other parts.
1.
Using a screwdriver or remover, remove the rear door delta inner cover (A).

2.
Using a screwdriver or remover, remove the rear door inside handle housing (A) and rear door pull handle cap (B).

3.
After loosening the mounting screws, then remove the rear door trim (A).

4.
Disconnect the rear door inside handle cable (A).

5.
Disconnect the power window switch connector (A).

6.
Install in the reverse order of removal.
  
Make sure the connector is connected properly.
Make sure the door locks/unlocks and opens/closes properly.
Replace any damaged clips.
Rear Door Trim Components and components location
Component Location   1. Rear door trim ...

Rear Door Inside Handle Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. After loosening the mounting scr ...

Other information:

Kia Cee'd JD Service Manual: Spark Plug Specifications
Specification   Item Specification Type SILZKR6810 Gap 0.9 ~ 1.0 mm (0.0354 ~ 0.0394 in.) ...

Kia Cee'd JD Service Manual: Troubleshooting
Basic Troubleshooting Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The measured resistance at high temperature after vehicle running may be high or lo ...

© 2017-2024 www.kceed.com