Kia Cee'd: Rear Door / Rear Door Module Repair procedures

Replacement

1.	Remove the rear door window glass. (Refer to Rear Door - "Rear Door Window Glass")

2.	Remove the rear door outside handle. (Refer to Rear Door - "Rear Door Outside Handle")

Loosen the rear door channel mounting bolt and nuts.

Tightening torque :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.	Remove the rear door channel (A).

5.	Loosen the outside handle base mounting bolt (A).

6.	Loosen the rear door latch (B) mounting screws.

After loosening the mounting bolts, then remove the rear door module (A).

Tightening torque :

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

8.	Disconnect the rear door module mounting clip (B).

9.	Disconnect the connectors and rear door module wiring harness (A).

10.

Install in the reverse order of removal.

•	The area of whole parts should be applied with sufficient grease.

•	Make sure connectors are connected properly and each rod is connected securely.

•	Make sure the door locks/unlocks and opens/closes properly

Component Location 1. Rear door module ...

Component Location 1. Rear door outside handle ...

Kia Cee'd JD Service Manual: Exhaust Manifold Repair procedures
Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal. 3. Disconnect the front and rear oxygen sensor connectors (A). 4. Re ...

Kia Cee'd JD Service Manual: Rear Console Cover Repair procedures
Replacement • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. ...