Replacement |
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
|
2. |
After loosening the mounting screws, then remove the rear door inside
handle (A).
|
3. |
Install in the reverse order of removal.
|
Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative ...
Kia Cee'd JD Service Manual: Repair procedures
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity exists
between the terminals below. If continuity is not as specified, replace the
multi-function switch.
Lighting Switch (Auto Light)
Lighting S ...