Kia Cee'd: Lighting System / Rear Combination Lamp Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Lighting System / Rear Combination Lamp Repair procedures

Removal

[5Door]

Rear Combination lamp (Inside)

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear combination lamp cover (A).

3.	Remove the mounting nuts (4EA) and disconnect the connector (A)..

4.	Remove the rear combination lamp (A).

5.	Remove the tail lamp (A).

Rear Combination Lamp (Outside)

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear lamp assembly (A) after removing the bolts and connector (B).

3.	Replace turn signal lamp bulb (A) turning it the counterclockwise direction.

[3Door]

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear combination lamp assembly (A) after loosening the screws.

3.	Disconnect the rear combination lamp connector (A).

4.	Replace the turn signal lamp bulb (A) and stop lamp bulb (B) turning it the counterclockwise direction.

Installation

[5Door]

1.	Install the rear combination lamp (Inside) assembly.

2.	Install the rear combination lamp (outside) assembly.

3.	Connect the negative (-) battery terminal.

[3Door]

1.	Install the rear combination lamp assembly.

2.	Connect the negative (-) battery terminal.

High Mounted stop lamp Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear spoiler assembly (A). (Refer to Body - "Rear S ...

Turn Signal Lamp Repair procedures

Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A) from the mirror holde ...

Other information:

Kia Cee'd JD Service Manual: Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM (ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM (ECM) request for vehicle specific data ...

Kia Cee'd JD Service Manual: IMS Control Switch Repair procedures
Inspection 1. Remove the IMS control switch connector (A). 2. With the IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the I ...