Kia Cee'd: Rear Bumper / Rear Bumper beam Assembly Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper beam Assembly Repair procedures

Replacement
  
Put on gloves to protect your hands.
  
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the cover and other parts.
1.
Remove the rear bumper cover.
(Refer to Rear Bumper - "Rear Bumper Cover")
2.
Disconnect the rear bumper beam mounting wiring harness (B).
3.
Detach the clips, then remove the rear bumper beam assembly (A).

4.
Install in the reverse order of removal.
  
Replace any damaged clips.
Make sure the connector is plugged in properly.
Rear Bumper beam Assembly Components and components location
Component Location   1. Rear bumper beam assembly ...

Front Seat
...

Other information:

Kia Cee'd JD Service Manual: Center Fascia Panel Components and components location
Component Location   1. Center fascia panel ...

Kia Cee'd JD Owners Manual: 2. Evaporative emission control System
The Evaporative Emission Control System is designed to prevent fuel vapors from escaping into the atmosphere. Canister Fuel vapors generated inside the fuel tank are absorbed and stored in the onboard canister. When the engine is running, the fuel vapors absorbed in the canister are dr ...

© 2017-2023 www.kceed.com