Kia Cee'd: Windshield Wiper/Washer / Rain Sensor Description and operation

Kia Cee'd JD Service Manual / Body Electrical System / Windshield Wiper/Washer / Rain Sensor Description and operation

Description

The Rain sensing windshield wiper system is a wiper system that, in addition to providing normal wiper functions off, mist, manual low speed, manual high speed, and wash, provides automatic control of automatic intermittent automatic low, and automatic high speeds.

When the ignition key is in the ON position, the rain sensor will be activated.

System Function

Basic Principle

Emitted Beam from luminosity diode is reflected entirely against the windshield exterior, and then turn into photo diode.

If there is water on the windshield exterior, beam seperates optically, and the degree of remained beam is measured in the photo diode.

What there is water in the windshield, it means beam is not reflected all, so the degree of lost beam indicates the degree of glass surface wet.

Rainsensor consist of two luminosity diode, two photo diode, optic fiber and coupling pad.

Operation Control

Wiper ECU transmits the signal as a rainsesor, and then the rainsensor perceives the rainwater to transmit to the wiping order wiper ECU, wiper ECU controls the wiper motor according to the signal.

Contact Influence

The rainsensor can malfunction due to following condition

•	Contamination of the measurement surface.

•	Air bubbles between the windshield and the coupling pad contact surface.

•	The movement of coupling pad by vibration.

•	Damaged wiper blade.

Operation Condition

In case that engine starts under wiper switch AUTO, rainsensor activates after once wiper operaion to inform the driver that the system is under AUTO.

In case that the rainsensor doesn't work or malfunction, it is needed manual wiper switch operation by the driver.

Rain Sensor Schematic diagrams

Circuit Diagram ...

Rain Sensor Repair procedures

Inspection Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are c ...

Other information:

Kia Cee'd JD Owners Manual: Heating
1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed control to the desired speed. 5. If dehumidified heating is desired, turn the air conditioning system on. • ...

: Pre-Collision Assist Precautions. Pre-Collision Assist Limitations
Pre-Collision Assist Precautions WARNING: You are responsible for controlling your vehicle at all times. The system is designed to be an aid and does not relieve you of your responsibility to drive with due care and attention. Failure to follow this instruction could result in the loss of cont ...