Kia Cee'd: Front Bumper / Radiator Grill Repair procedures

Replacement
  
Put on gloves to protect your hands.
  
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Loosen the radiator grill upper cover mounting clips.
3.
Unlock the lock pins (B) by pushing it up with a screwdriver or remover and then remove the radiator grill upper cover (A).

4.
Disconnect the front bumper energy absorber mounting wiring harness (C).
5.
Detach the clips (B), then remove the front bumper energy absorber (A).

6.
Remove the radiator grill mounting rivet and then loosen the screws.
7.
Unlock the lock pins (B) by pushing it up with a screwdriver or remover and then remove the radiator grill (A).

8.
Install in the reverse order of removal.
  
Replace any damaged clips.
Radiator Grill Components and components location
Component Location   1. Radiator grill ...

Rear Bumper
...

Other information:

Kia Cee'd JD Service Manual: Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. &nb ...

Kia Cee'd JD Owners Manual: Heating
1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed control to the desired speed. 5. If dehumidified heating is desired, turn the air conditioning system on. • ...

© 2017-2025 www.kceed.com