Kia Cee'd: Heater / PTC Heater (Gasoline Engine) Description and operation

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Heater / PTC Heater (Gasoline Engine) Description and operation

Descriptionddd
The PTC (Positive Temperature Coefficient) heater is installed at the exit or the backside of the heater core.
The PTC heater is an electric heater using a PTC element as an auxiliary heating device that supplements deficiency of interior heat source in highly effective gasoline engine. The electric heater heats up the interior by directly heating the air that passes through the heater. The name itself implies that the element has a proportional resistance change sensitive to temperature.

Operation Principle
Heater control outputs a PTC ON signal and operates PTC relay 1. Then heater controller operates PTC relay 2 and PTC relay 3 with an interval of 15 seconds.
However, PTC relay 3 can be operated while battery voltage is above 12.4V.
Operating Condition
PTC heater operates according to the following conditions :
Battery voltage : 13.0V or above
Engine : 900 rpm or above
Ambient temperature and coolant temperature
 
Ambient
Temperature
Coolant
Temperature
PTC
Operation
Below -20°C
(-4°F)
Below 75°C (167°F)
ON
5°C (41°F)
Below 65°C (149°F)
ON
7°C (44.6°F) or above
-
OFF
-
80°C (176°F) or above
OFF

PTC Heater (Diesel Engine) Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) ...

PTC Heater (Gasoline Engine) Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) ...

Other information:

Kia Cee'd JD Service Manual: Steering Column and Shaft Repair procedures
Replacement 1. Remove the steering wheel. (Refer to Steering Wheel - "Steering Wheel Assembly") 2. Remove the steering column shroud. 3. Remove the clock spring. 4. ...

Kia Cee'd JD Owners Manual: Follow the steps 1 to 7 from the previous chapter.
8. Remove the cover by turning it counterclockwise. 9. Disconnect the headlight bulb socketconnector. 10. Unsnap the headlight bulb retaining wire by depressing the end and pushing it upward. 11. Remove the bulb from the headlight assembly. 12. Install a new headlight bulb and snap the h ...

© 2017-2024 www.kceed.com