Kia Cee'd: Windows / Power windows
The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door’s window. The driver’s door has a master power window switch that controls all the windows in the vehicle. Also, the driver has a power window lock switch which can block the operation of rear passenger windows. The power windows can be operated for approximately 30 seconds after the ignition key is removed or turned to the ACC or LOCK position. However, if the front doors are opened, the power windows cannot be operated even within the 30 seconds period.
✽ NOTICE
While driving with the rear windows down or with the sunroof (if equipped) in an open (or partially open position), your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is a normal occurrence and can be reduced or eliminated by taking the following actions. If the noise occurs with one or both of the rear windows down, partially lower both front windows approximately one inch. If you experience the noise with the sunroof open, slightly reduce the size of the sunroof opening.
WARNING
Do not install any accessories in the area of windows. It may impact jam protection.
Windows
(1) Driver’s door power window switch
(2) Front passenger’s door power window
switch
(3) Rear door (left) power window
switch* (for 5 Door and wagon)
(4) Rear door (right) power window
...
Window opening and closing
Type A
To open or close a window, press down
or pull up the front portion of the corresponding
switch to the first detent position
(5).
Type B - Auto up/down window
(if equipped)
Pressi ...
Other information:
Kia Cee'd JD Service Manual: Heater Unit Components and components location
Component Location
Components
1. Heat Case (Left)
2. Heat Case (Right)
3. Separator
4. Defog Door
5. Vent Door
6. Vent Guide
7. Temp Door
8. Mode Control Actuator
9. Temperature Control Actuator (Left)
10. Temper ...
Kia Cee'd JD Service Manual: Rear Upper Arm Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 1 ...
