Inspection |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position according
to the table. If the continuity condition is not normal, replace the
switch.
[4Door All Safety(LHD)]
[4Door All Safety(RHD)]
[2Door All Safety(LHD)]
[2Door All Safety(RHD)]
[2Door Auto Down(LHD)]
[2Door Auto Down(RHD)]
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position according
to the table. If the continuity condition is not normal, replace the
switch.
[Safety Up/Down]
[Manual Down]
|
Kia Cee'd JD Service Manual: Troubleshooting
Troubleshooting
Problem
Possible cause
Solution
Not pairing
Bluetooth device of Car is not discoverable mode
Enter Bluetooth pairing (searching) mode
User’s phone is Bluetooth off ...
Kia Cee'd JD Service Manual: Luggage Side Trim Repair procedures
Replacement
[5Door]
•
Put on gloves to protect your hands.
•
...