Kia Cee'd: Blower / Power Mosfet (DATC) Repair procedures

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Blower / Power Mosfet (DATC) Repair procedures

Inspection

1.	Turn the ignition switch ON.

2.	Manually operate the control switch and measure the voltage of the blower motor.

Select the control switch to raise the voltage until high speed.

Specification

Fan Speed (Manual)	Motor Voltage (V)
Fan Speed (Manual)	MANUAL FAN SPEED	AUTO FAN SPEED
1	3.4	Auto Low (4.0)
2	4.6	4.0 ~ 5.5
3	5.9	5.5 ~ 6.7
4	7.2	6.7 ~ 7.7
5	8.3	7.7 ~ 8.9
6	9.5	8.9 ~ 10.1
7	11.3	10.1 ~ Auto Hi (11.3)
8	B+

* MANUAL FAN SPEED : (3.4V ~ B+)

* AUTO FAN SPEED : (4.0V ~ B+)

4.	If the measured voltage is not within specification, substitute with a known-good power mosfet and check for proper operation.

5.	If the problem is corrected, replace the power mosfet.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the connector (A) and then remove the power mosfet (B) after loosening the mounting screws.

3.	Install in the reverse order of removal.

Blower Resistor (Manual) Repair procedures

Inspection 1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resist ...

Climate Control Air Filter Description and operation

Description The climate control air filter is located in the blower unit. It eliminates foreign materials and odor. The particle filter performs a role as an odor filter as well ...

Other information:

Kia Cee'd JD Owners Manual: Dual clutch transmission (DS mode) shift indicator
The indicator displays which Dual clutch transmission shift lever is selected. In DS mode, the “SPORTS” indicator displays in cluster. For more detailed information about DS mode, refer to the chapter 5. CAUTION - DCT When the problem of gear system occurs, the transaxle indic ...

Kia Cee'd JD Service Manual: Heated Washer Nozzle Repair procedures
Removal 1. Remove the cowl top cover. (Refer to the BD group - "Cowl Top Cover") 2. Disconnect the heated washer nozzle connectors (A). 3. Remove the heated washer nozzle (A) aft ...