Inspection |
1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
2. |
Remove the front door module.
(Refer to Body - "Front Door Module")
|
3. |
Disconnect the connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
[Central Lock]
[Dead Lock]
|
5. |
Check for continuity between the terminals in each switch position according
to the table.
[Central Lock]
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
2. |
Remove the rear door module.
(Refer to Body - "Rear Door Module")
|
3. |
Disconnect the connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
[Central Lock]
[Dead Lock]
|
5. |
Check for continuity between the terminals in each switch position according
to the table.
[Central / Dead Lock]
|
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
2. |
Disconnect the connector from the actuator.
|
3. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the tailgate open switch bracket (A) after loosening screws.
|
2. |
Remove the switch and disconnect the connector from the switch.
|
3. |
Check for continuity between the terminals in each switch position according
to the table.
|
Kia Cee'd JD Owners Manual: Service mode
This mode calculates when you need a
scheduled maintenance service (mileage
or days)
If you want to see the service mode when
other modes are displayed, press the
button less than 1 second.
If you do not have your vehicle serviced
according to the scheduled maintenance
service on ...
Kia Cee'd JD Service Manual: IMS (Integrated Memory System) module Repair procedures
Removal
1.
Remove the negative (-) battery terminal.
2.
Remove the driver seat in the car.
(Refer to Body - "Front Seat Assembly")
3.
Remove the IMS module (A) after loosening 3 screws i ...