Kia Cee'd: SRSCM / PAB ON/OFF Switch Repair procedures

Kia Cee'd JD Service Manual / Restraint / SRSCM / PAB ON/OFF Switch Repair procedures

Removal

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Remove the crash pad side cover. (Refer to Body - "Crash pad side cover")

4.	Disconnect the PAB ON/OFF switch connector (A).

5.	Remove the PAB ON/OFF switch.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Install the PAB ON/OFF switch to the crash pad side cover.

4.	Connect the PAB ON/OFF switch connector.

5.	Install the crash pad side cover. (Refer to Body - "Crash pad side cover")

After installing the SRSCM, confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

PAB ON/OFF Switch Components and components location

Components ...

Airbag Module

...

Other information:

Kia Cee'd JD Service Manual: Ignition Coil Description and operation
Description An ignition coil is an induction coil in an engine's ignition system which transforms the battery's low voltage to the high voltage needed to create an electric spark in the spark plugs to ignite the fuel. Coils have an internal resistor while others rely ...

: SYNC Mobile Apps
The system enables voice and steering wheel control of SYNC AppLink enabled smartphone apps. When an app is running through AppLink, you can control main features of the app through voice commands and steering wheel controls. Note: You must pair and connect your smartphone to SYNC to access Ap ...