Kia Cee'd: BSD (Blind Spot Detection) / LCA (Lane Change Assist) / Operating conditions

To operate:

Press the BSD switch with the Ignition switch in the ON position.

The indicator on the BSD switch will illuminate. When the vehicle speed exceeds 30 km/h (20 mph), the system will be activated.

To cancel:

Press the BSD switch again. The indicator on the switch will go off.

When the system is not used, turn the system off by turning off the switch.

✽ NOTICE

The system will activate when:

1. The system is on.
2. The vehicle speed is above about 30 km/h (20 mph).
3. An oncoming vehicle is detected in the blind spot area.

First stage alert

1st stage

If a vehicle is detected within the boundary of the system, an amber warning light will illuminate on the outside rearview mirror.

Once the detected vehicle is no longer within the blind spot area, the warning will turn off according to the driving conditions of the vehicle

Second stage alert

2st stage

A warning chime to alert the driver will activate when:

1. A vehicle has been detected in the blind spot area by the radar system (the warning light will illuminate on the outside rearview mirror) AND

2. The turn signal is applied (same side as where the vehicle is being detected).

When this alert is activated, the warning light on the outside rearview mirror will also blink.

If you turn off the turn signal indicator, the warning chime will be deactivated.

- The second stage alarm can be deactivated.

CAUTION

The alarm function helps alert the driver. Deactivate this function only when it is necessary

BSD (Blind Spot Detection) / LCA (Lane Change Assist)
...

Non-operating condition
The sensors are located inside of the rear bumper. Always keep the rear bumper clean for the system to work properly. WARNING The warning light on the outside rearview mirror will illum ...

Other information:

Kia Cee'd JD Owners Manual: Battery recharging
Your vehicle has a maintenance-free, calcium-based battery. If the battery becomes discharged in a short time (because, for example, the headlights or interior lights were left on while the vehicle was not in use), recharge it by slow charging (trickle) for 10 hours. If the ba ...

Kia Cee'd JD Service Manual: Gear Actuator Motor Description and operation
Description The gear actuator motor is mounted on the complete shaft. The gear actuator motor comprises the shift motor and select motor. The gear actuator shift motor and select motor receive signals from the Transmission Control Module (TCM) to control the gear. ...

© 2017-2022 www.kceed.com