Kia Cee'd: Lubrication System / Oil Pressure Switch Repair procedures

Kia Cee'd JD Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Repair procedures

Removal and Installation

1.	Remove the under cover.

2.	Remove the oil drain plug, and drain the oil into a container.

Remove the oil pressure switch(A).

Tightening torque :

7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

4.	Install in the reverse order of removal.

Inspection

1.	Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.

2.	Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch.

3.	If there is no continuity when a 49.0kpa (0.5kg/cm², 7.1psi) is applied through the oil hole, the switch is operating properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.

Oil Pump Repair procedures

Removal and Installation 1. Remove the timing chain cover. (Refer to Timing System - "Timing Chain Cover") 2. Remove ...

Oil Pan Components and components location

Components 1. Gasket 2. Oil screen 3. Oil pan 4. Drain plug gasket 5. Drain plug ...

Other information:

Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform [NON-ISG] This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to dete ...

Kia Cee'd JD Owners Manual: Using Voice Recognition
Starting Voice Recognition Shortly press the key on the steering wheel Say a command. If voice recognition is in [Normal Mode], then the system will say “Please say a command. Beep~” If voice recognition is in [Expert Mode], then the system will only say a “Beep~” To ...