Kia Cee'd: Heater / Mode Control Actuator Description and operation

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Heater / Mode Control Actuator Description and operation

Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control actuator based on signal of A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Temperature Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. ...

Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify ...

Other information:

Kia Cee'd JD Service Manual: Front Door Side Weatherstrip Repair procedures
Replacement 1. Detach the clips, then remove the front door side weatherstrip (A). 2. Install in the reverse order of removal.    ...

Kia Cee'd JD Service Manual: Rear Stabilizer Bar Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 1 ...

© 2017-2026 www.kceed.com