Kia Cee'd: Manual Transaxle System / Manual Transaxle Oil Repair procedures

Inspection
Manual Transaxle Oil level Check
  
Check intervals: 40000 miles / 4years (60000 km / 4 years)
If a leak is detected, leak repair and oil level check should be performed.
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the oil filler plug (A).

3.
Check the condition of the oil and make sure that it is at the proper level (A).

4.
Install the oil filler plug (A).
Tightening torque :
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.8 lb-ft)

  
The existing oil filler plug gasket must be replaced with new one. (Do not reuse it.)
5.
Install the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
Replacement
  
The manual transaxle oil does not need to be replaced in normal driving condition, but in severe driving conditions, it should be replaced every 80,000 miles (120,000 km ). Severe driving conditions are as follows.
Driving in rough road (bumpy, gravel, snowy, unpaved road, etc.)
Driving in mountain road, ascent/descent
Repetition of short distance driving
More than 50% driving in heavy city traffic in hot weather above 30°C (89.6°F) .
Police cars, taxis, commercial vehicles or towing vehicles, etc
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the drain plug (A), allow the oil to drain out and then reinstall the drain plug.
Tightening torque :
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.8 lb-ft)

  
The existing oil drain plug gasket must be replaced with new one. (Do not reuse it.)
3.
Remove the oil filler plug (A).

4.
Fill the manual transaxle with manual transaxle oil through the filler hole.
Recommended :
- SAE 70W, API GL-4
• The list of transaxle oil approved by KIA: SK HK MTF 70W, SHELL SPIRAX S6 GHME 70W, GS CALTEX GS MTF HD 70W
Quantity :
1.6 ~ 1.7 ℓ (0.42 ~ 0.45 U.S.gal., 1.69 ~ 1.80 U.S.qt., 1.41 ~ 1.50 lmp qt.)
  
Make sure that oil level is at the proper level (A).

5.
Install the oil filler plug (A).
Tightening torque :
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.8 lb-ft)

  
The existing oil filler plug gasket must be replaced with new one. (Do not reuse it.)
6.
Install the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
Manual Transaxle System
...

Manual Transaxle Components and components location
Components   1. Manual transaxle assembly 2. Manual transaxle support bracket 3. Clutch release bearing 4. Clutch release fork 5. Control cable brac ...

Other information:

Kia Cee'd JD Service Manual: Front Stabilizer Bar Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque: 88.2 ~ ...

Kia Cee'd JD Service Manual: Components and components location
Component Location   1. Fuel filler door ...

© 2017-2024 www.kceed.com