Kia Cee'd: Automatic climate control system / Manual heating and air conditioning

The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of buttons or knob(s) selected.

1. Start the engine.

2. Set the mode to the desired position. To improve the effectiveness of heating and cooling:
- Heating:
- Cooling:

3. Set the temperature control to the desired position.

4. Set the air intake control to the outside (fresh) air or recirculated position.

5. Set the fan speed control to the desired speed.

6. If air conditioning is desired, turn the air conditioning system on.

Press the AUTO button in order to convert to full automatic control of the system.

Automatic heating and air conditioning
The automatic climate control system is controlled by simply setting the desired temperature. Soft mode Fast mode You can choose either the soft mode or fast mode to select the fan speed. ...

Mode selection
The mode selection button controls the direction of the airflow in the vehicle. If you push the button once, the corresponding switch will turn on, and if you push the button again, the swit ...

Other information:

Kia Cee'd JD Service Manual: Rear Door Belt Inside Weatherstrip Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door belt inside weatherstrip (A). 3. Install in the reverse order of removal ...

Kia Cee'd JD Owners Manual: Air cleaner
Filter replacement It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed air. 1. Loosen the air cleaner cover attaching clips and open the cover. 2. Wipe the inside of the ...

© 2017-2025 www.kceed.com