Kia Cee'd: Fuses / Main fuse
Electrical equipments are not working even though inner panel and engine compartment fuses are not blown, or many of these are not working at the same time, it may has blown the main fuse(Battery Fuse Terminal type) inside of the battery(+) cap.
If the main fuse is blown, it must be removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the nuts shown in the picture above.
4. Replace the fuse with a new one of the same rating.
5. Reinstall in the reverse order of removal.
CAUTION
- After checking the main fuse, install the cover securely when you close the cover, check the locking sound. If not, electrical failures may occur from water leaking in.
- Visually inspect the battery cap for secure closing. If the battery cap is not securely latched, the electrical system may be damaged to due influx of moisture into the system.
Engine compartment panel fuse
replacement
Diesel only
1. Turn the ignition switch and all other
switches off.
2. Remove the fuse box cover by pressing
the tap and pulling up. When the
blade type fuse is disconnected,
remove it b ...
Multi fuse
If the multi fuse is blown, it must be
removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the fuse panel on the right
side in the engine compartme ...
Other information:
Kia Cee'd JD Service Manual: ETC (Electronic Throttle Control) System Troubleshooting
Fail-Safe Mode
Item
Fail-Safe
ETC Motor
Throttle valve stuck at 7°
TPS
TPS 1 fault
ECM looks at TPS2
TPS 2 fault
ECM looks at TPS1
TP ...
Kia Cee'd JD Owners Manual: Sound Settings
Audio Settings
Press the key Select
[Sound] Select [Audio Settings]
Use the ,
,
,
buttons to
adjust the Fader/Balance settings.
Use the , buttons to adjust the
Bass/Middle/Treble settings.
Press the button to reset.
SDVC (Speed Dependent Volume
Control)
Press the key Select ...
