Kia Cee'd: Engine Control System / Knock Sensor (KS) Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Engine Control System / Knock Sensor (KS) Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
3.
Disconnect the injector connector (A).
4.
Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Installation
  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)
Knock Sensor (KS) Schematic diagrams
Circuit Diagram ...

Heated Oxygen Sensor (HO2S) Description and operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output vol ...

Other information:

Kia Cee'd JD Service Manual: Rear Door Window Glass Components and components location
Component Location   1. Rear door window glass ...

: Audio Voice Commands
___ is a dynamic listing, meaning that for audio voice commands it can be the name of a Sirius channel or a channel number, a radio frequency number, or the name of an artist, album, song or a genre. To control the media features, press the voice button and when prompted, say: 1 This option m ...

© 2017-2026 www.kceed.com