Kia Cee'd: Engine Control System / ISG (Idle Stop & Go) Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Engine Control System / ISG (Idle Stop & Go) Repair procedures

Inspection

1.	Remove the ISG switch from the switch assembly.

2.	Check the continuity between the switch 3 and 6 terminals as the ISG OFF switch is engaged.

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the crash pad low switch assembly (A) from the switch panel on the crach pad of the driver's side.

Installation

1.	Installation is reserve of removal.

ISG (Idle Stop & Go) Description and operation

Description Idle Stop & Go (ISG) system switches off the ignition when vehicle is stopped, and then restarts the ignition and starts the vehicle when accelerator is pushed. I ...

ISG (Idle Stop & Go) Schematic diagrams

Schematic Diagram 1. C-CAN High/Low 2. MIL. Lamp 3. Immobilizer 4. Canister 5. Manifold Absolute Pressure Sensor (MAPS) 6. Intake Air Temperat ...

Other information:

Kia Cee'd JD Service Manual: Fuel Filter Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the electric pump & sender wiring connector (A). 3. Remove the fuel feed tube (A) from ...

Kia Cee'd JD Service Manual: Troubleshooting
Troubleshooting Problem Symptoms Table Use the table below to help you find the cause of the problem. The numbers indicate the priority of the like cause of the problem. Check each part in order. If necessary, replace these parts. Symptom ...