Kia Cee'd: Engine Control System / Intake Air Temperature Sensor (IATS) Repair procedures
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the IATS connector.
|
3. |
Measure resistance between the IATS terminals 3 and 4.
|
4. |
Check that the resistance is within the specification.
Specification: Refer to “Specification”
|
|
1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
3. |
Remove the installation bolt (B), and then remove the sensor from the
surge tank.
![](images/intake_air_temperature_sensor_iats_repair_procedures-953/752/smdfl1045d.gif)
|
• |
Install the component with the specified torques.
|
• |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
• |
Insert the sensor in the installation hole and be careful not
to damage.
|
|
1. |
Installation is reverse of removal.
Intake air temperature sensor (IATS) installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
Description
Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage
of the cylinder head for detecting the engine coolant temperature. The ECTS
uses a t ...
Other information:
Kia Cee'd JD Service Manual: Specifications
Specifications
IMS Electrical System
Item
Specification
Rating voltage
DC 12V
Operating voltage
DC 9V ~ 16V
Operating temperature
-30°C ~ +80°C
...
Kia Cee'd JD Owners Manual: Front fog light
Fog lights are used to provide improved
visibility when visibility is poor due to fog,
rain or snow, etc. The fog lights will turn
on when the fog light switch (1) is turned
on after the position light is turned on.
To turn off the fog lights, turn the fog light
switch (1) to the O (Off ...