Kia Cee'd: Dual Clutch Transmission Control System / Input Speed Sensor 1 Repair procedures

Inspection
Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor.
Removal
1.
Turn off the ignition switch and then disconnect the battery (-) cable.
2.
Remove the under cover.
3.
Disconnect the input shaft speed sensor connector (A).

4.
Loosen the mounting bolt and then remove the input shaft speed sensor (B).

Installation
1.
Install in the reverse order of removal.
Tightening torque :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
Input Speed Sensor 1 Schematic diagrams
Schematic Diagrams ...

Input Speed Sensor 2 Description and operation
Description The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM). It provides i ...

Other information:

Kia Cee'd JD Service Manual: Components and components location
Component Location   1. Panoramaroof 2. Panoramaroof switch 3. Panoramaroof motor & controller 4. Roller blind motor & slave controller ...

Kia Cee'd JD Service Manual: Components and components location
Components   1. Windshield side molding 2. Windshield glass ...

© 2017-2025 www.kceed.com