Kia Cee'd: Dual Clutch Transmission Control System / Input Speed Sensor 1 Description and operation

The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM).

It provides important input information for electric control.

The information is needed in all operations, including feedback control, gear shift control and failure detection of other sensors.

Gear Actuator Motor Repair procedures

Inspection 1. Turn off the ignition switch. 2. Disconnect the shift actuator connector (A) and select actuator connector (B). ...

Input Speed Sensor 1 Specifications

Specification Input Speed Sensor 1 ▷ Type: Hall effect sensor ▷ Specifications   Item Specifications Output voltage (V) ...

Other information:

Kia Cee'd JD Service Manual: Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. &nb ...

Kia Cee'd JD Service Manual: Relay Box (Passenger Compartment) Description and operation
Description Smart Junction Box(SJB) 1. General function : Interior Junction Box + some functions of BCM It controls loads with CAN communication and IPS. 2. Main function – Low speed C ...