Kia Cee'd: Dual Clutch Transmission Control System / Inhibitor Switch Description and operation

The inhibitor switch is mounted on the transmission case. It includes the electric switch plate circuit and is directly connected with the transmission lever via transmission cable.

When the driver shifts the transmission lever, the contact point on the switch plate varies and the electric current process changes, and engages the gear intended by the driver.

In addition, the inhibitor switch cuts off power from the circuit to prevent the motor from running if the driver attempts to start the engine from any gear positions other than P or N.

Input Speed Sensor 2 Repair procedures

Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Turn off the ignition switch and then disconnect the batte ...

Inhibitor Switch Specifications

Specification ▷ Type: Single signal output type ▷ Specifications   Item Specifications Output type Combined sign ...

Other information:

Kia Cee'd JD Service Manual: Battery Repair procedures
Removal 1. Disconnect the battery (-)terminal (A) and then (+)terminal (B). 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 3. Re ...

: Locating the Safety Compliance Certification Labels. What Is the Gross Axle Weight Rating. What Is the Gross Vehicle Weight Rating. What Is the Gross Combined Weight Rating
Locating the Safety Compliance Certification Labels Safety Compliance Certification Label Example: The Safety Compliance Certification label is located on the door hinge pillar, door-latch post, or the door edge that meets the door-latch post, next to the driver seating position. What Is the G ...