Kia Cee'd: Electronic stability control (ESC) / Indicator light

When ignition switch is turned to ON, the indicator light illuminates, then goes off if the ESC system is operating normally.

The ESC indicator light blinks whenever ESC is operating or illuminates when ESC fails to operate.

ESC OFF indicator light comes on when the ESC is turned off with the button.

CAUTION

Driving with varying tire or wheel sizes may cause the ESC system to malfunction. When replacing tires, make sure they are the same size as your original tires.

WARNING

The Electronic Stability Control system is only a driving aid; use precautions for safe driving by slowing down on curved, snowy, or icy roads. Drive slowly and don’t attempt to accelerate whenever the ESC indicator light is blinking, or when the road surface is slippery.

ESC operation off
ESC OFF state This car has 2 kinds of ESC off states. If the engine stops when ESC is off, ESC remains off. Upon restarting the engine, the ESC will automatically turn on again. • ESC o ...

ESC OFF usage
When driving ESC should be turned on for daily driving whenever possible. To turn ESC off while driving, press the ESC OFF button while driving on a flat road surface. WARNING Never ...

Other information:

Kia Cee'd JD Owners Manual: OFF
With manual transaxle To turn off the engine (START/RUN position) or vehicle power (ON position), stop the vehicle then press the engine start/stop button. With automatic transaxle/DCT* To turn off the engine (START/RUN position) or vehicle power (ON position), press the engine start/ ...

Kia Cee'd JD Service Manual: BJ Boot Repair procedures
Replacement 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”) 3. Rem ...

© 2017-2024 www.kceed.com