Kia Cee'd: Hood / Hood Assembly Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Hood / Hood Assembly Repair procedures

Replacement
  
Be careful not to damage the hood and body.
  
When removing and installing the hood, an assistant is necessary.
When removing the clips, use a clip remover.
1.
After loosening the hood hinge (B) mounting bolts, remove the hood assembly (A).
Tightening torque :
21.6~26.5 N.m (2.2~2.7 kgf.m, 15.9~19.5 lb-ft)

2.
Install in the reverse order of removal.
  
Make sure the hood locks/unlocks and opens/closes properly.
Adjust the hood alignment.
Hood Assembly Components and components location
Component Location   1. Hood assembly ...

Hood Weatherstrip Repair procedures
Replacement 1. Remove the hood weatherstrip (A). 2. Install in the reverse order of removal. ...

Other information:

Kia Cee'd JD Owners Manual: Static bending light
While driving the corner, for your sight and safety, the static bending light turns on automatically. The system will operate automatically as follows: When vehicle speed is under 10km/h and steering wheel angle approximately 80 degrees. When vehicle speed is over 10km/h and ste ...

Kia Cee'd JD Owners Manual: Operating condition
This system will activate when the indicator on the rear parking assist OFF button is not illuminated. If you desire to deactivate the rear parking assist system, press the rear parking assist OFF button again. (The indicator on the button will illuminate.) To turn the syste ...

© 2017-2024 www.kceed.com