Kia Cee'd: Heater / Heater Core Repair procedures
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the heater & blower assembly.
(Refer to Heater - "Heater Unit")
|
3. |
Remove the heater core cover (A) after loosening the mounting screws.

|
4. |
Pull out the heater core (A) from heater unit.

|
5. |
Installation is the reverse order of removal.
• |
If you're installing a new evaporator, add refrigerant oil (PAG
OIL).
|
• |
Replace the O-rings with new ones at each fitting, and apply
a thin coat of refrigerant oil before installing them. Be sure
to use the right O-rings for R-134a or R-1234yf to avoid leakage.
|
• |
Immediately after using the oil, replace the cap on the container,
and seal it to avoid moisture absorption.
|
• |
Do not spill the refrigerant oil on the vehicle; it may damage
the paint; if the refrigerant oil contacts the paint, wash it
off immediately
|
• |
Apply sealant to the grommets.
|
• |
Make sure that there is no air leakage.
|
• |
Charge the system and test its performance.
|
• |
Do not interchange the inlet and outlet heater hoses and install
the hose clamps securely.
|
• |
Refill the cooling system with engine coolant
|
|
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
...
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater & blower assembly.
(Refer to Heater - &q ...
Other information:
Kia Cee'd JD Owners Manual: Floor mat anchor(s)
When using a floor mat on the front floor
carpet, make sure it attaches to the floor
mat anchor(s) in your vehicle. This keeps
the floor mat from sliding forward.
WARNING
The following must be observed
when installing ANY floor mat to
the vehicle.
Ensure that the floor mats are
...
Kia Cee'd JD Service Manual: Panoramaroof Motor Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the connector (A).
4 ...