Kia Cee'd: Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 2 and 5 [B1/S1].
4.
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
5.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the connector (A), and then remove the sensor (B).
  
Note that the SST (Part No.: 09392-1Y100) is useful when removing the heated oxygen sensor.

[Bank 1 / Sensor 1]

[Bank 1 / Sensor 2]

Installation
  
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  
DON’T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.
Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).
1.
Installation is reverse of removal.
Heated oxygen sensor installation:
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
Heated Oxygen Sensor (HO2S) Schematic diagrams
Circuit Diagram ...

Rail Pressure Sensor (RPS) Description and operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor ele ...

Other information:

Kia Cee'd JD Service Manual: Troubleshooting
Troubleshooting   Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel bearing Replace ...

Ford Escape 2020-2025 Owners Manual: Connecting a Trailer Precautions
WARNING: Do not adjust the spring bars so that your vehicle's rear bumper is higher than before attaching the trailer. Doing so will defeat the function of the weight-distributing hitch, which may cause unpredictable handling, and could result in serious personal injury. Do not tow a trailer u ...

© 2017-2025 www.kceed.com